20" Walker Turner Drill Press Model 1100

by Lou
(Warsaw NY)

This drill press was setup with a bowling ball drill fixture which nicely protected the table which does have a few dings from dropped bits etc. It is equipped with a Balder 1HP 1140 rpm motor and was wired for 220 vac single phase. When I received it it had a heavy coat of pale yellow enamel over a coat of "Bowling Shirt" turquoise over the origonal gray. It will be necessary to strip most if not all of it.
Also included in the deal were about 100# of taper shank drill, some just HSS most being carbide. Before disassembly it was test run on temperary wiring and it is exceptionally smooth at all speeds.